The top supplier and manufacturer of: Adhesives, Abrasives, Polyresin, Chemical...
Go to Home Page Main Products Product Showroom Main Services Contact Us Tieng Viet
Glue, Adhesives
Abrasive, Sand Paper
Chemical Materials
Textile, Clothing & Garment
Technology

Decorwood
Cyanoacrylate 502 || PVAC-Polyvinyl Acetates || Epoxy Resins || Polymer || EVA Emulsion
ADHESIVES - GLUE

502 Adhesives
  • Cyano aclylate CA-W20, CA-152: The remarkable chemical and physical properties of ethyl cyanoacrylate led to their use as instant adhesive. The highly polar character of the hardened polymer permits the formation of very strong bonds between a wide variety of materials.
  • Technical Data
    Characteristics Tensile Shear Strength (Kg/cm3)
  • Viscosity, Shelf life and Setting Time:
    - Product No: CA-W20, CA-152
    - Cps: 2
    - Months: 6
    - Steel: 5
    - Alum: 5
    - Copper: 3
    - ABS: 3
    - PMMA: 5
    - PVC: 3
  • Appearance: colorless transparent liquid.
  • Rockwell Hardness: 85
  • Linear Expansion Coefficient: 0.01%
  • Heat Stability: no deterioration after 48 hrs at 100deg C
    		• - Product No: CA-W20, CA-152
    - Steel: 190
    - Alum: 145
    - Copper: 160
    - ABS: *
    - PMMA: *
    - PVC: *
  • Application Method
    - Surfaces to be bonded should be clean.
    - Make a small hole on the top of the bottle tip with a tiny pin. Be careful not to splash into eyes.
    - Apply a small amount to one surface. The amount used should be small because too much adhesive will not make a good bond. Immediately joint to other surface and press to spred the adhesive evenly. It will bond in seconds and maximum strength is reached after 24 hours.
    - Should be stored in cool, dark and dry place. Storage in refrigerator or freezer is advised, however it should be adjusted to room temperature when bottle is opened for use.
    - Cleaning: adhesive bonds maybe dissolved in aceton, M. E. K., ethyl acetate, cyclohexane, preferably melting the polymer at 160deg C and then wipe the hot malt mass off before cleaning with the solvents.
    - Safety precaution: Avoid contact with eyes. If it gets into the eye, should be rinsed with tap water for 15 minutes and call on an ophthalmologist. When eyelid are stuck with the adhesive, press with steamed hot towel and eyelid maybe opened by the perspiration.
    - Important: Do not try to take apart strongly or scrub with hand. It will hurt the eye. In case of fingers contact and cannot be separated, put the fingers in warm water for a while and then separate slowly. If still adhered strongly, use solvent such as acetone to remove and then wash with soap water.
    • Next
    News Board
    Nam Quang Company LTD. The best of the Adhesives, Abrasives, Chemicals, Materials, Plastic and household products in Vietnam.
    New Products

    Lơ Đánh Bóng

    keo Hotmelt - cây - miếng

    HYDRO PEROXUYT - CHẤT TẪY
    Nam Quang Company
    553/21 Nguyen Kiem Street, Ward 9 – Phu Nhuan District, Hochiminh city.
    Tel: (84-8) 8450411 - Fax: (84-8) 8446067 - Mobile: (84) 903.925576
    Powered by ACEvn.com